CONNECTICUT STATUTES AND CODES
Sec. 20-331. Examining boards.
Sec. 20-331. Examining boards. (a) There shall be in the Department of Consumer
Protection separate examining boards for each of the following occupations: (1) Electrical work; (2) plumbing and piping work; (3) heating, piping, cooling and sheet metal
work; (4) elevator installation, repair and maintenance work; (5) fire protection sprinkler
systems work; and (6) automotive glass work and flat glass work.
(b) The Electrical Work Board shall consist of twelve members who shall be residents of this state, one of whom shall be a general contractor or an unlimited contractor
licensed for such occupation under this chapter, two of whom shall be unlimited contractors licensed for such occupation under this chapter, neither of whom at the time of
appointment shall be a member or an employee of a member of a trade union or a party
or an employee of a party to a contract with a trade union, one of whom shall be an
electronic technician licensed under chapter 394, four of whom shall be unlimited journeymen licensed for such occupation under this chapter, who at the time of appointment
shall be members of a trade union and four of whom shall be public members.
(c) The Heating, Piping, Cooling and Sheet Metal Work Board shall consist of
twelve members who shall be residents of this state and, except as otherwise provided in
this subsection, (1) one of whom shall be a general contractor or an unlimited contractor
licensed to perform heating, piping and cooling work under this chapter, (2) two of
whom shall be unlimited contractors licensed to perform heating, piping and cooling
work under this chapter, neither of whom at the time of appointment shall be a member
or an employee of a member of a trade union or a party or an employee of a party to a
contract with a trade union, (3) one of whom shall be a limited contractor licensed to
perform sheet metal work under this chapter, provided such member's powers and duties
on the board shall be limited to matters concerning sheet metal work, as defined in
subdivision (13) of section 20-330, (4) three of whom shall be unlimited journeymen
licensed to perform heating, piping and cooling work under this chapter, who at the time
of appointment shall be members of a trade union, (5) one of whom shall be a journeyman
sheet metal worker, who at the time of appointment shall be a member of a trade union,
provided such member's powers and duties shall be limited to matters concerning sheet
metal work, as defined in subdivision (13) of section 20-330, and (6) four of whom shall
be public members. Each person who is a member of the board on October 1, 1999,
shall continue to serve at the pleasure of the Governor. Only the members appointed
pursuant to subdivisions (1), (3), (5) and (6) of this subsection may consider and act
upon matters concerning sheet metal work, as defined in subdivision (13) of section
20-330.
(d) The Plumbing and Piping Work Board shall consist of twelve members who
shall be residents of this state, one of whom shall be a general contractor or an unlimited
contractor licensed for such occupations under this chapter, two of whom shall be unlimited contractors licensed for such occupations under this chapter, neither of whom at
the time of appointment shall be a member or an employee of a member of a trade union
or a party or an employee of a party to a contract with a trade union, one of whom shall
be a well drilling contractor licensed pursuant to section 25-129, four of whom shall be
unlimited journeymen licensed for such occupations under this chapter, who at the time
of appointment shall be members of a trade union, and four of whom shall be public
members.
(e) The Elevator Installation, Repair and Maintenance Board shall consist of eight
members who shall be residents of this state, three of whom shall be unlimited contractors, two of whom shall be elevator craftsmen, licensed for such occupation under this
chapter, and three of whom shall be public members, provided at least one of the unlimited contractors shall be a member of either the National Association of Elevator Contractors or the National Elevator Industries, Incorporated.
(f) The Fire Protection Sprinkler Systems Board shall consist of nine members who
shall be residents of this state, two of whom shall be journeymen sprinkler fitters, two
of whom shall be fire protection sprinkler contractors, three of whom shall be public
members, one of whom shall be a representative of the State Fire Marshal and one of
whom shall be a local fire marshal.
(g) The Automotive Glass Work and Flat Glass Work Board shall consist of nine
members who shall be residents of this state, one of whom shall be a general contractor
or an unlimited contractor licensed to perform automotive glass work under this chapter,
one of whom shall be a general contractor or an unlimited contractor licensed to perform
flat glass work under this chapter, one of whom shall be an unlimited contractor licensed
to perform automotive glass work under this chapter, one of whom shall be an unlimited
contractor licensed to perform flat glass work under this chapter, one of whom shall be
an unlimited journeyman licensed to perform automotive glass work under this chapter,
one of whom shall be an unlimited journeyman licensed to perform flat glass work under
this chapter and three of whom shall be public members. The initial members appointed
under this subsection need not be licensed to perform such work under this chapter
before January 1, 2001, provided such initial members shall satisfy the applicable criteria
set forth in subsection (e) of section 20-334a. On and after January 1, 2001, each member
appointed under this subsection shall be licensed as provided in this subsection.
(h) The contractor and journeymen or elevator craftsmen members of each board
established under this section shall be appointed by the Governor from a list of names
submitted by employers' and employees' associations in the respective occupations.
The Governor may fill any vacancy occurring in the membership of any such board,
may remove any member for cause, after notice and hearing, and shall remove any
licensed member whose license is not renewed or whose license has become void, revoked or suspended. Each member of such boards shall, before entering upon the duties
of such member's office, take the oath provided by law for public officers. Members
shall not be compensated for their services but shall be reimbursed for necessary expenses incurred in the performance of their duties.
(February, 1965, P.A. 493, S. 2; 1967, P.A. 789, S. 2; P.A. 77-614, S. 184, 610; Nov. Sp. Sess. P.A. 81-11, S. 11, 19;
P.A. 82-404, S. 2, 4; P.A. 85-352; P.A. 86-293; P.A. 87-588, S. 3, 8; P.A. 89-25, S. 1, 3; 89-164, S. 1, 2; P.A. 93-151, S.
2, 4; 93-435, S. 57, 95; P.A. 98-3, S. 24; P.A. 99-73, S. 2; 99-170, S. 2; 99-253, S. 2; June 30 Sp. Sess. P.A. 03-6, S. 146(d);
P.A. 04-169, S. 17; 04-189, S. 1; P.A. 06-126, S. 1.)
History: 1967 act updated statute to conform with Sec. 20-330 and to provide for appointment of members replacing
original members, changed requirement that 4 of members be contractors or journeymen, specified contractor, journeymen
or craftsmen members be licensed rather than eligible to be licensed and that such licenses be unlimited and changed date
for submitting list of names to governor from July first to May first of year in which appointments are to be made; P.A.
77-614 placed boards within consumer protection department, increased number of members from 5 to 7, deleted member
who is not engaged in profession or eligible for license, added 3 public members, deleted provision setting May first date
for submission of list of nominees, July first appointment date and six-year terms and deleted provision for biennial election
of board officers, effective January 1, 1979; Nov. Sp. Sess. P.A. 81-11 replaced provision whereby members received
"only necessary and reasonable expenses" incidental to duties with provision specifying that members receive no compensation but are to be reimbursed for expenses incurred in performing duties; P.A. 82-404 increased membership of elevator
installation and maintenance board from 7 to e8ight, adding one unlimited contractor to the board, and required that at
least one of the unlimited contractors be a member of one of two specified professional associations; P.A. 85-352 provided
that the electrical examining board shall include a general contractor among its members, increasing the membership from
7 to 8; P.A. 86-293 increased the membership of the heating, piping and cooling board and the plumbing and piping board
from 7 to 9 members, required that such boards include a general contractor and increased number of journeymen members
from 2 to 3; P.A. 87-588 established the fire protection sprinkler systems board, effective July 1, 1988; P.A. 89-25 removed
the requirement that members of the plumbing and piping board, heating, piping and cooling board, electrical board and
elevator installation, repair and maintenance board who are required to be licensed for the occupation overseen by the
board on which they serve also be engaged in such occupation; P.A. 89-164 reorganized the membership of the electrical,
plumbing and piping and heating, piping and cooling boards, effective July 1, 1991; P.A. 93-151 increased the membership
of the plumbing and piping work board from 6 members to 12 members by adding a registered well driller, an unlimited
journeyman and a public member effective June 14, 1993; P.A. 93-435 substituted reference to registration for reference
to licensure of well drilling contractors, effective June 28, 1993; P.A. 98-3 divided section into Subsecs. and made technical
changes; P.A. 99-73 divided existing Subsec. (b) into new Subsec. (b) increasing the membership of the Electrical Work
Board from 9 to 12 members and specifying their qualifications, and new Subsec. (c) describing the Heating, Piping and
Cooling Work Board, relettering the existing Subsecs. accordingly and making technical changes; P.A. 99-170 made
gender neutral change, amended Subsec. (a) to add new Subdiv. (6) placing the Automotive Glass Work and Flat Glass
Work Examining Board within the department, inserted Subsec. (g) to establish the membership of the Automotive Glass
Work and Flat Glass Work Board and relettered the remaining Subsec. accordingly; P.A. 99-253 amended Subsec. (a) to
expand jurisdiction of heating, piping and cooling examining board to include sheet metal work, amended Subsec. (b) to
delete the reference to the Heating, Piping and Cooling Work Board, creating a new Subsec. (c) re Heating, Piping, Cooling
and Sheet Metal Work Board, and relettered the remaining Subsecs. accordingly; June 30 Sp. Sess. P.A. 03-6 and P.A.
04-169 replaced Department of Consumer Protection with Department of Agriculture and Consumer Protection, effective
July 1, 2004; P.A. 04-189 repealed Sec. 146 of June 30 Sp. Sess. P.A. 03-6, thereby reversing the merger of the Departments
of Agriculture and Consumer Protection, effective June 1, 2004; P.A. 06-126 amended Subsec. (c) to specify that only
members appointed pursuant to Subdivs. (1), (3), (5) and (6) may consider and act upon matters concerning sheet metal work.
See title 2c re termination under "Sunset Law".
See Sec. 4-9a for definition of "public member".
See Secs. 21a-6 to 21a-10, inclusive, re control, powers and duties of boards within Department of Consumer Protection.
Cited. 209 C. 719.
Cited. 22 CA 181.