IC 13-19-3
Chapter 3. Powers and Duties Concerning Solid Waste and
Hazardous Waste Management
IC 13-19-3-1
Regulation of solid and hazardous waste and atomic radiation;
review orders; development of operating policies
Sec. 1. The solid waste management board shall do the following:
(1) Except as provided in sections 3 through 4 of this chapter,
adopt rules under IC 4-22-2 to regulate solid and hazardous
waste and atomic radiation in Indiana, including rules necessary
to the implementation of the federal Resource Conservation and
Recovery Act (42 U.S.C. 6901 et seq.), as amended.
(2) Develop operating policy concerning the activities of the
department.
(3) Carry out other duties imposed by law.
As added by P.L.1-1996, SEC.9. Amended by P.L.25-1997, SEC.14.
IC 13-19-3-2
Orders; review by environmental law judge
Sec. 2. (a) The commissioner may enter into agreed orders as
provided in IC 13-30-3-6.
(b) An environmental law judge under IC 4-21.5-7 shall review
orders and determinations of the commissioner.
As added by P.L.1-1996, SEC.9.
IC 13-19-3-3
Prohibited areas of regulation
Sec. 3. The board may not adopt rules under section 1 of this
chapter to regulate the following:
(1) The disposal of waste indigenous to the coal mining process
and coal combustion products (as defined by ASTM
E-2201-02a), including fly ash, bottom ash, boiler slag,
fluidized bed combustion ash, or flue gas desulfurization
material produced from the combustion of coal or the cleaning
of stack gases on coal combustion units if the material:
(A) is not included in the definition of hazardous waste or is
exempt from regulation as a hazardous waste under 42
U.S.C. 6921; and
(B) is disposed of at a facility regulated under IC 14-34.
(2) The use of coal combustion products (as defined by ASTM
E-2201-02a), including fly ash, bottom ash, boiler slag,
fluidized bed combustion ash, or flue gas desulfurization
material produced from the combustion of coal or the cleaning
of stack gases on coal combustion units, if the use includes one
(1) of the following uses:
(A) The extraction or recovery of materials and compounds
contained within coal combustion products.
(B) Bottom ash as an antiskid material.
(C) Raw material for manufacturing another product.
(D) Mine subsidence, mine fire control, and mine sealing.
(E) Structural fill when combined with cement, sand, or
water to produce a controlled strength fill material.
(F) A base in road construction.
(G) Cover for coal processing waste disposal locations to
inhibit infiltration at surface and underground mines subject
to IC 14-34, so long as a demonstration is made in
concurrence with the department of natural resources that
the materials and methods to be employed are appropriate
for the intended use.
(H) Providing buffering or enhancing structural integrity for
refuse piles at surface and underground mines subject to
IC 14-34, so long as a demonstration is made in concurrence
with the department of natural resources that the materials
and methods to be employed are appropriate for the intended
use.
(I) Agricultural applications, when applied using appropriate
agronomic amounts to improve crop or vegetative
production.
As added by P.L.1-1996, SEC.9. Amended by P.L.215-2003, SEC.4.
IC 13-19-3-4
Vertical expansions of existing permitted landfills; rules prohibited
Sec. 4. Except as provided by sections 5 and 6 of this chapter, the
board and the department may not adopt rules under section 1 of this
chapter to:
(1) prohibit; or
(2) arbitrarily restrict;
vertical expansions of existing permitted landfills.
As added by P.L.1-1996, SEC.9. Amended by P.L.122-1996, SEC.3.
IC 13-19-3-5
Vertical expansions of existing permitted landfills; environmental
assessments
Sec. 5. Notwithstanding federal regulations, the board and the
department shall adopt rules under section 1 of this chapter that
require an applicant for a vertical expansion of an existing permitted
landfill to submit environmental assessments as part of the
application, including the following:
(1) Hydrogeology of the existing landfill site and adjacent
areas.
(2) Evaluation of groundwater.
(3) Operational history of the landfill.
(4) Identification of adjacent land uses.
As added by P.L.1-1996, SEC.9.
IC 13-19-3-6
Vertical expansions of existing permitted landfill; submission of
design, engineering, and operational requirements
Sec. 6. Notwithstanding federal regulations, the board and the
department shall adopt rules under section 1 of this chapter that
require the applicant for a vertical expansion of an existing permitted
landfill to submit design, engineering, and operational requirements,
including the following:
(1) A more precise definition of the hydrogeology of the site,
including a soil gas analysis.
(2) Operational requirements.
(3) Surface water control plan.
(4) Landfill gas control plan.
(5) Final cover requirements.
(6) Closure and financial assurance plans.
(7) Remedial action plan.
As added by P.L.1-1996, SEC.9.
IC 13-19-3-7
Use of foundry sand
Sec. 7. The department and the boards shall allow a person to use
foundry sand that meets Type III criteria under 329 IAC 10-9 for the
following activities in accordance with guidance without requiring
the person to obtain any permits from the department:
(1) As a daily cover for litter and vermin control at a landfill in
accordance with any applicable permits issued for the landfill.
(2) As a protective cover for a landfill leachate system in
accordance with any applicable permits issued for the landfill.
(3) For use as capped embankments for ground and sight
barriers under ten thousand (10,000) cubic yards or
embankments for airports, bridges, or overpasses.
(4) For use:
(A) in a land application operation; or
(B) as a soil amendment;
if the application or amendment does not include the operation
of a landfill.
(5) As a structural fill base capped by clay, asphalt, or concrete
for the following:
(A) Roads.
(B) Road shoulders.
(C) Parking lots.
(D) Floor slabs.
(E) Utility trenches.
(F) Bridge abutments.
(G) Tanks and vaults.
(H) Construction or architectural fill.
(I) Other similar uses.
(6) As a raw material constituent incorporated into another
product, including the following:
(A) Flowable fill.
(B) Concrete.
(C) Asphalt.
(D) Brick.
(E) Block.
(F) Portland cement.
(G) Glass.
(H) Roofing materials.
(I) Rock wool.
(J) Plastics.
(K) Fiberglass.
(L) Mineral wool.
(M) Lightweight aggregate.
(N) Paint.
(O) Plaster.
(P) Other similar products.
As added by P.L.129-1997, SEC.2. Amended by P.L.30-1999, SEC.3;
P.L.14-2000, SEC.37.
IC 13-19-3-7.2
Rules for voluntary certification programs
Sec. 7.2. (a) The board may adopt rules under IC 4-22-2 and
IC 13-14-9 to develop a voluntary certification program for persons
that remediate sites where releases of hazardous substances (as
defined in IC 13-11-2-98) or petroleum (as defined in
IC 13-11-2-160) have occurred.
(b) The rules adopted under this section must establish, at a
minimum, the following:
(1) Eligibility criteria for certification.
(2) Criteria and procedures for suspension or revocation of
certification.
(3) A certification application fee.
(c) The department may audit remediations performed by persons
certified under rules adopted under this section.
As added by P.L.131-1997, SEC.1.
IC 13-19-3-8
Use of slag
Sec. 8. The board may not adopt rules under section 1 of this
chapter to regulate the following activities involving the legitimate
use of slag generated by the production of iron or steel under Bureau
of the Census Standard Industrial Classification 3312:
(1) Production of slag.
(2) Transportation of slag.
(3) Storage of slag.
(4) Processing of slag.
(5) Legitimate use of slag.
As added by P.L.257-2001, SEC.1.
IC 13-19-3-8.2
Permit modification to prohibit processing or disposal of solid
waste
Sec. 8.2. The department may modify a permit to prohibit the
processing or disposal of specific solid waste at:
(1) a solid waste disposal facility; or
(2) a solid waste processing facility.
As added by P.L.218-2001, SEC.6.
IC 13-19-3-9
Constructiondemolition waste; setback requirements
Sec. 9. (a) This section does not apply to an expansion of a solid
waste landfill:
(1) that accepts only constructiondemolition waste; and
(2) for which a constructiondemolition waste permit was issued
before January 1, 2005.
(b) A solid waste landfill that accepts only
constructiondemolition waste shall comply with setback
requirements concerning public schools established by the board
under 329 IAC 10-16-11 for municipal solid waste landfills.
As added by P.L.189-2005, SEC.2.